Create an "Edit Multiple" command to works on all types of devices. Include only attributes that are common to all types of devices: layer system, elevation.

Right now, one has to edit all the blocks of a panel schedule in order to simply change the font. There should be a way to set the preferred font for all these schedules. If there is a way, I don't know about it. When I first set up DM 10 years or so ago, I do not remember having to change every block, but it's been so long ago...

Be able to show conduits feeder runs on their own layer with up and down riser symbols. Then be able to create a conduit schedule.

Add new column to the equipment schedule that would display the length of the branch circuit.

We do a lot of low voltage design, and when we circuit on the drawings, the only option for circuiting is a loop. With multiple low voltage systems on one drawing (door locks, intercoms, CCTV, access control, RFID, duress alarms, paging, etc.), looped circuiting looks messy and can be confusing. It would be nice to have other types of circuiting available that is more linear.

Often when circuiting I find the location DM puts the label is very poor. It would be nice if after inserting the circuit I could move the circuit text without having to stop the circuiting action, move the text, then start the circuiting action again.

When defining rooms, it is often difficult to determine which rooms have been defined and which have not, if an area gets surrounded. Adding a hatch pattern on its own layer would make it much easier to determine if you've included all room definition areas.

DesignMaster currently loops devices using arcs. We'd like an option to change looping from using arcs to use polylines (we differentiate between MC cable and conduits with arcs and polylines, respectively). Ideally these polylines would offset themselves similar to how feeder polylines are offset during one-line generation.

Label homeruns using feeder IDs like those used in the one-line diagram instead of full text wire callouts.

So that when I am working on a multilevel building all I would have to do is copy the floor plan from one identical level and placing it on the other matching levels then just rename the panels and circuit names, without duplicating the copied information on the original panels. Breaking its connection with the parent panel and giving a notification to reassign panel names.

Make possible not only the easy DM insertion of these devices onto the lighting plan but also the ability to account for these in the panel schedule and load calculations.

Improve the "Copy and Increment" command to work across drawings. Make it easier to move everything from one panel to a different panel on the copied devices.

Add a check box to set the voltage for a building. If a building is 120/240, then checking a box will set the default for panels, equipment, etc to 120/240v instead of 120/2083p4w.

The service ground does not get installed in the conduit with the service entrance conductors, so why is it shown just like all the other feeders where the equipment grounding conductor is installed with the feeder conductors. If you want the feature to show the GEC size, show it in a different column and show the feeder with no ground listed with the feeder conductors so its clear it is not in the conduit.

I would like to suggest that the photometric calculation schedule be a combined schedule for all rooms instead of a dedicated schedule for each single room/space (or both options be available). We are typically asked to provide a single schedule that lists the room/space name in the first column and then the various footcandle columns.

Be able to insert a receptacle/device without picking it from the 'Insert Receptacle' form. A command followed by the device name would prompt the user to place the receptacle like they just clicked "OK" after selecting a device.

When wiring I have more often than not had to manually loop my devices for a better looking presentation but the only problem is that the wires loose their intelligence and become as regular polylines. I would like to see an intelligent manual line which auto breaks and shows the tick marks just like the auto looping feature does please.

It would be helpful when creating distribution equipment lists if there was an option for the manufacturer's name. Currently we have to use an unused Note key, rename the label for that key and then remember which Notes Setting corresponds to the list entry.