Add support for annotative scale factors for blocks and text. This would allow blocks and text to be the same size in different scaled viewports.

Would make sense to add a note field in the equipment connection creation form or in the circuiting form to tag individual breakers with specific requirements, possibly with a superscript which refers to a box of notes attached to the bottom of the schedule.

Automatically upsize branch circuit wires when necessary because of voltage drop.

Add specific support for subfeed breakers.

Be able to set the number of subfeed breakers on a panel (similar to how the number of poles is currently set on a panel).

Have the panel schedule update to document which breakers are subfeed. We likely would add a separator block between the branch circuit and subfeed breakers that you could customize. The default block would have a line across the schedule plus some text indicating branch circuit breakers above and subfeed below. You could then modify that as desired for your documentation purposes.

Add a Schedule of all blocks used in the project. This could be used a Symbol Legend for the Project.

Create a schedule of VAV boxes, similar to the diffuser schedule.

When copying circuits in the swap and copy dialog, multipole breakers do not copy to the new location as multipole breakers, they copy as single pole. It appears that you have to set the number of poles and their positions in the circuiting dialog before starting the copy/swap routine.

Some HVAC and other pieces of equipment require multiple circuits for multiple loads inside each unit. Currently I have to create 2 pieces of equipment with the individual loads, overlay them, then circuit them.

Have a way to create a generic schedule. The schedule will be informational purposes only, but it will be generated the same way as the other DM schedules so it will look the same.

Specify the exhaust air requirements for rooms and use these numbers in the load calculations and duct design calculations.

Export a list of equipment connections and information to a file that can be opened and viewed in Excel. The file would be for post-processing only. Any changes to the equipment would still be made using the other DM commands.

Have the option to insert diffusers at the corner of the diffuser, not the center. This change would assist in placing diffusers properly in ceiling grids.

When you loop from one device to another, be able to select that loop and break it in to two loops that can each individually be moved or broke. This way we can have "S" loops.

DM Note: When we implement this, it will probably be by allowing you to insert a loop using a pline. This will allow you to insert the loop however you want without any restrictions.

Insert the load calculation schedules on the drawing.

If you could add the ability to create plan or keynotes to all devices and fixtures, you could eliminate some of the notes that occupy space beside them. Typically a hex box, circle would have the keynote number in it, which would refer you to a common list of notes on the edge of the space. Keeping them tied to the respective annotation layers may help keep them sortable by the entities on that sheet.

We need the note fields for Panels and Switchboards to be larger and editable like the Description, Model, and Note fields in the Light Fixture Project Schedule.

The ability to define an egress fixture as the same fixture/block as the normal fixtures, with an option to turn a hatch on/off to differentiate. Similar to in Revit, where you can set an instance parameter and check it to turn fixtures into the egress blocks. The fixture type stays the same, only the visible block changes.